New Holland DuraSwath™ 440 HB


Windrower Headers DuraSwath™ 440 HB



Powerful Speedrower® SP Windrowers allow you to drive a wide variety of high-performance headers. Choose from two powerful disc headers—the Durabine™ 416 with a 16’ 1” cut, or the Durabine™ 419 with an industry-widest 19’ 4” cut. New Holland offers a large selection of draper headers—from 25 to 40 feet wide. Haybine® sicklebar headers have a legendary history of top cutting and conditioning performance, and are available with a 14, 16 or 18foot cut.

Model DuraSwath™ 440 HB
Header drive  
Cutting width ft. in. (m) 40 (12.2)
Overall width ft. in. (m) -
Approximate weight lbs. (kg) 7300 (3311) includes reel
Versions available Double-knife drive, single swath, split reel
Windrow/swath width in. (mm) 56 - 72 (1420 - 1830) center delivery windrow width
Cutterbar type SCH ProDrive system; hydraulically-driven, planetary-reduction sickle drive, NH cutting system w/Standard or Stub Guards, or Schumacher (EasyCut)
Knives -
Knife speed 1400 SPM
Sickle stroke in. (mm) 3.35 (85)
Flotation -
Cutting angle and height, degrees, in (m) Minimum 0.75 (19) @ 8 degrees tilt
Header ground clearance - bottom of skid shoes in. (mm) 47 (1200) w/tilt cyl. fully retracted; 43 (1100) w/tilt cyl. fully extended
Reel Choices (SF = steel fingers, PF = plastic fingers) UII, 6-bat, split, w/PF; HCC, 6-bat, flipover, w/PF
Speed range rpm 10 – 75
Drive Single reels equipped with single, hydraulic-driven, chain-and-sprocket reduction drive w/15.9ci (260cc) motor; Split reels equipped with two, hydraulic-driven, chain-and-sprocket reduction drive w/15.9ci (260cc) motors
Raptor Draper Belts  
Belt width and construction 42 in. (1.07 m) rubberized polyester belt with fiberglass reinforcement, tie bar end connection
Belt/roller guide design V-guide on upper end of inner side of belt with V-groove in rollers
Roller design Rubber vulcanized steel drive roller, steel idler roller
Speed range ft. (m) 0 - 760 (0-232)/minute
Cleat design and height in. (mm) 1/2" (13) high cleat, w/embedded fiberglass reinforcement
Chaff barrier seal design Continuous, 1/2" height, rubber, inverted 'V' barrier on front edge of outside of belt, w/minimal clearance to draper guard
Belt angle degrees (@minimum cutterbar tilt) 15 @ 2 degrees tilt
Type -
Maximum diameter in. (mm) -
Flighting depth in. (mm) -
Conditioner (Rolls)  
Type -
Length in. (m) -
Roll speed rpm -
Roll pressure -
Roll gap -
Conditioner (Flails)  
Length in. (m) -
Speed rpm -
Hood position -

Fields with asterisks* and highlighted red are required. Please email our helpful staff with any questions or comments using the contact form.

Fields with asterisks* and highlighted red are required. Your friend will receive an email that contains a reference to this page. Please send this email only to people you know who would be interested in this information.

RANCHRITE hardware available at Western Implement